30
ATTENTION:
AFTER EACH NEW PACKING OR INTEGRATION OF THE RESERVE SYSTEM INTO
THE OUTER CONTAINER, IT IS RECOMMENDED THAT THE CORRECT INSTAL-
LATION OF THE SYSTEM BE CHECKED TO INSURE THAT THE CONTAINER WILL
OPEN PROPERLY, WHEN ACTUATING THE RELEASE GRIP OR HANDLE, AND
MAKE SURE THAT THE OUTER CONTAINER OPENS CORRECTLY IN CONNEC-
TION WITH THE RELEASE PIN AND GRIP, AND THAT THE ATTACHMENT OF PIN
WITH THE HARNESS RELEASE HANDLE IS IN PROPER WORKING ORDER.
CONNECTION OF THE RESERVE CHUTE WITH THE HARNESS:
The connecting lines of the Reserve chute are to be properly fastened to the Reserve
connecting lines or straps of the harness, located at the shoulder, through connection
of a suitable steel screw clamp. It is absolutely necessary that this steel screw triangu-
lar clamp, be positioned in the middle of the clamp leading up to the shoulder harness,
where both harness connecting lines are symmetric to the clamp. In the event that
the harness does not have an integrated fastening point for the Reserve system at the
shoulder, then the Reserve system connecting lines may be attached to the main cara-
biner at the shoulder.
ATTENTION:
THE RESERVE SYSTEM MUST ALWAYS BE THROWN ON THE SIDE WHERE THE
CONNECTING LINES OF THE HARNESS ARE LOCATED.
MAINTENANCE
The skywalk PEPPER2 light rescue should be repacked at least every 6 months, as de-
tailed in the packing instructions. We always recommend that this rescue parachute
is inspected and repacked by a trained professional repacker. Additional inspections
should be performed if there is any suspicion of damage or undue wear. After a deploy-
ment, the rescue should be checked by the distributor or manufacturer. Always seek
To Next Page
Loading...
Need help?
General