EasyManua.ls Logo

Slant/Fin B-120A - User Manual

Slant/Fin B-120A
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
IMPORTANT
READ ALL OF THE FOLLOWING WARNINGS AND
STATEMENTS BEFORE READING THE
INSTALLATION INSTRUCTIONS
WARNING
LIQUEFIED PETROLEUM (L.P.)
PROPANE GAS-FIRED BOILERS
Installation location ONLY as permitted in paragraph
entitled "LIQUEFIED PETROLEUM (L.P.) PROPANE GAS-
FIRED BOILER LOCATION" on page 5 of this instruction
book.
The above warning does not apply to NATURAL
gas fired boilers.
The installation must conform to the requirements of the
authority having jurisdiction or, in the absence of such
requirements, to the National Fuel Gas Code, ANSI Z223.1-
latest edition or
CSA B149.1-05 for natural gas and
propane. The installation must also conform to the
additional requirements in this Slant/Fin Instruction Book.
In addition, where required by the authority having juris dic -
tion, the installation must conform to American Society of
Mechanical Engineers Safety Code for Controls and Safety
Devices for Automatically Fired Boilers, No. CSD-1 or
CSA
B149.1-05 for natural gas and propane. If there is any
conflict in the above requirements, then the more stringent
requirement will apply.
WARNING
This boiler, gas piping and accessories must be
installed, connected, serviced and repaired by a
trained, experienced service technician, familiar with all
precautions required for gas-fired equipment and
licensed or otherwise qualified, in compliance with the
authority having jurisdiction.
WARNING
The venting system of this boiler is under positive pressure. Leakage
from this system can be hazardous and if not avoided can result in
death or serious injury. In addition to the recommendations within this
manual and the User’s Information Manua
l, the venting system, from
the flue collector to the outdoor discharge, must be carefully checked
annually by a qualified service agency.
This manual must be left with owner and should be
hung on or adjacent to the boiler for reference.
BOBCAT
INSTALLATION AND OPERATING INSTRUCTIONS
Printed in Canada 0711 Part No. 86-5736 Publication No. B -40 Rev. G
Heating Contractor
Address
Phone Number
Boiler Model Number
Boiler Serial Number
Installation Date
DIRECT-VENT SEALED COMBUSTION CONDENSING BOILER
HOT WATER MODELS B-120A and B-200A
GAS-FIRED BOILERS FOR NATURAL AND L.P. PROPANE GASES
TABLE OF CONTENTS
Dimensions, Rating and Orifice Sizes...........................................2
Identification of Parts.....................................................................3
Installation Requirements..............................................................4
Contamination Prevention.............................................................5
Mounting the boiler on a wall ........................................................6
Venting Application........................................................................6
Boiler Room Air Supply and Ventilation ........................................6
Non-Direct Vent Installation...........................................................6
Flue Gas Venting Requirements ...................................................7
Additional Installation Requirements for Massachusetts..............7
Vent and Air Intake Material...........................................................7
PVC/CPVC Pipe General Assembly Method ................................8
Vent and Air Intake Restrictions ....................................................8
Sidewall Venting, Non-Direct Vent ................................................9
Vent Termination Location and Clearance ....................................9
Non-Direct Vent Vertical Venting ...................................................9
Direct Vent Installation...................................................................9
Sidewall Venting, Direct Vent ........................................................9
Alternate Sidewall venting for direct or non-direct venting.........14
Vent/Air Intake Termination Installation .......................................16
Direct Vent, Venting and Air Intake through a Roof ....................17
Venting and Air Intake Regular Inspection..................................18
Condensate Removal System.....................................................18
Gas Piping ...................................................................................18
Electrical Wiring...........................................................................19
Wiring Diagram............................................................................20
Single and Multi Zoning ..............................................................22
Water Piping ................................................................................24
Operating Instructions.................................................................30
Boiler Control Display..................................................................30
Boiler Control...............................................................................30
Sequence of Operation ...............................................................36
Gas Input Rate Adjustment .........................................................37
Safety Check ..............................................................................38
Care and Maintenance................................................................41
General Troubleshooting Guide..................................................42
Appendix A&B ............................................................................43

Other manuals for Slant/Fin B-120A

Question and Answer IconNeed help?

Do you have a question about the Slant/Fin B-120A and is the answer not in the manual?

Summary

Boiler Specifications and Identification

Specifications

Detailed specifications including fuel input, water volume, connections, and weight.

Parts Identification Diagram

Diagram showing location and names of key boiler components.

Installation Requirements and Safety

Minimum Clearances and Location

Clearances, location, foundation requirements.

Contamination Prevention

Products and areas to avoid for clean combustion air.

Boiler Mounting Procedures

Step-by-step instructions for wall mounting the boiler.

Venting and Air Intake Systems

Venting Application and Boiler Room Air

Types of venting and air supply needs for the boiler room.

Non-Direct vs. Direct Vent Installation

Methods for drawing combustion air from ambient or outside.

Flue Gas Venting Requirements

Essential instructions for safe and effective venting of combustion gases.

Vent Pipe Assembly and Restrictions

Pipe joining methods and length limitations.

Sidewall Venting Procedures

Specifics for sidewall installation of vent and air intake.

Vertical Venting and Chimney Use

Installation for venting through roof or using existing chimney.

Alternate Sidewall Venting

Methods for sidewall venting to ensure snow line clearance.

Vent;Air Intake Termination

Details and illustrations of termination units.

System Piping, Controls, and Operation

Condensate Removal and Gas Piping

Condensate disposal system and gas piping installation requirements.

Electrical Wiring and Diagrams

Instructions for wiring, schematic, and control diagrams.

Multizone System Wiring

Wiring for zone valve and pump zoning multizone systems.

Water Piping and Treatment

System connections, circulator pumps, and water quality guidelines.

Operating Instructions and Boiler Control

Filling, venting, checks, and control panel features.

Boiler Settings, Safety, and Troubleshooting

Boiler Display Board Operation

Layout and status modes of the boiler display board.

Viewing and Changing Temperatures

How to view and adjust supply, return, and tank temperatures.

System Settings and Testing

Accessing and modifying system settings and performing tests.

Initial Start, Safety, and Sequence of Operation

First start procedures, safety warnings, and operational flow.

Combustion, Fuel Rate, and Error Codes

Checking combustion, adjusting rates, and understanding error codes.

General Troubleshooting Guide

Diagnosing and resolving common boiler operational issues.

Maintenance and Appendices

Care and Maintenance Procedures

Guidelines for general, annual, and seasonal maintenance tasks.

Appendices: Thermostat Settings and Deposits

Information on thermostat anticipation and heat exchanger deposits.

Slant/Fin B-120A Specifications

General IconGeneral
BrandSlant/Fin
ModelB-120A
CategoryBoiler
LanguageEnglish

Related product manuals