‣
Filling will take approximately and is complete when the pump motor
ceases to work and a “click” is heard.
3. When Slayer has filled completely, move the brew actuators left, into the
“on” positions.
4. When water begins to run from the groupheads, return the brew actuator to
the "off" position.
‣
Leave steam actuators in the “on” positions for “Step 8: Turn on Heating
Elements”.
Step 8: Turn On Heating Elements
1. Per step 7, ensure that both steam actuators are pulled forward, into the
“on” positions.
2. Move the white heating element switch to the "on" position by flipping it to
the left.
3. The machine is heated when steam begins to flow from the steam wand; at
this point, move the steam actuators into the “off” positions.
4. Lift to remove cup tray and check the inside of the machine for leaks or
collected water.
5. Allow Slayer to fully heat before use.
To Next Page
Loading...
Need help?
General
