Manual_MPS_2021-10-022.00_EN.docx 11
/28
7.2 INITIAL STATE OF THE DISPLAY
While the device is in standard working mode, the display shows the home screen
(actual date, time and the temperatures), including the target temperature in brackets.
Explanation Date/Function Time/Settings
Actual date / time 17.09.10 16:45:00
Paraffin tank temperature (actual vs. target) Paraffin 60 ºC (65 ºC)
Surface temperature (actual vs. target) Surface 38 ºC (40 ºC)
Cooling Spot status Cooling
Spot
Off
Home Screen of the Display: MPS P
Within this view there are no options for manual settings as it only provides an
indication of the actual status of the device.
The names and sequence of the temperature controllers depend on the device:
• MPS C, MPS CX Surface
• MPS W Upper / Lower
• MPS P Paraffin / Surface / Cooling Spot (only On / Off)
• MPS P I Paraffin / Surface / Bowl / Cooling Spot (only On / Off)
Devices which are not equipped with every single function have an empty line instead of
actual and target temperature for the built-in feature, e.g., MPS C only has a line for
surface temperature but shows no other information.
7.3 STANDBY MODE
If the Standby mode is activated, the display indicates date, time and the starting time for
the following operation cycle, if the timer is programmed. If no timer program is set, the
device shows that the heating / cooling functions are switched off. The standby mode
lasts until the next time the device is started by the timer or the user.
Standby display for MPS P:
Explanation Date/Function Settings
Actual date / time 17.09.10 20:45:00
Timer settings for paraffin tank Paraffin >> Fr07:00
Timer settings for surface Surface >> Fr09:00
Cooling Spot status Cooling Spot
Off
To Next Page
Loading...
Need help?
General