12/28 Manual_MPS_2021-10-022.00_EN.docx
Standby display for MPS P I:
Explanation Date/Function Settings
Actual date / time 17.09.10 20:45:00
Timer settings for paraffin tank Paraffin >> Fr07:00
Timer settings for surface Surface >> Fr09:00
Timer settings for cassette / mould storage Bowl >> Fr09:00
Standby display for MPS W:
Actual Date / Time 17.09.10 20:45:00
Timer settings for upper heating Upper >> Fr07:00
Timer settings for lower heating Lower >> Fr09:00
Standby display for MPS C and MPS CX:
Explanation Date/Function Settings
Actual date / time 17.09.10 20:45:00
Timer settings for surface Surface >> Fr09:00
Within this view there are no options for manual settings as it only provides an indication
of the actual status of the device.
While the device is in standby mode, the display illumination is switched off and all
functions, even light and Peltier element are set inactive. To reactivate the apparatus the
second menu item in the Main Menu, named Operation must be selected. Alternatively,
the device will be switched on by the timer, if it is programmed.
7.4 MAIN MENU
The table Main Menu provides the possible settings of the MPS P and MPS P I software.
The columns Cursor, Function and Settings are a representation of the characters shown
on the display. As the display only shows 4 lines you can navigate to the other positions
listed in the following tables by pressing . The menu will roll down to all included items.
The item Configuration is only available for technicians authorized by SLEE medical GmbH.
To Next Page
Loading...