TIRE INFLATOR SET-UP INSTRUCTIONS
1. For use with 12-volt DC power outlet rated 15 amps or higher.
Do not use with older 8 amp cigarette lighter receptacles.
2. You may need to be in “accessory” or “on” position. Please
make sure emergency brake is set and car is in park. Always
ensure air hose chuck touches the core of the valve stem for
proper inflation.
3. Inflator is not designed for use on high pressure tires such as
truck tires. This inflator is not designed to operate for the length
of time it would take to inflate these large tires.
4. WARNING: DO NOT use inflator continuously for more than
10 minutes. Inflator is designed for occasional use ONLY.
Extended operation will overheat the unit causing damage.
Sluggish operation or exposed metal fittings too hot to the
touch indicate the unit has been operating too long. If either
occurs, turn the unit OFF and allow to cool for 25 minutes or
more prior to resuming operation.
5. Do not leave inflator unattended while the unit is running.
ALWAYS use a pressure gauge to check actual tire pressure.
DO NOT OVERINFLATE!
To Next Page
Loading...
