TECH SPECS
TIRE INFLATION TIME
CFM
COIL AIR HOSE LENGTH
POWER CORD LENGTH
POWER SOURCE
IN-LINE DIAL GAUGE
LIGHT
* (0-35 PSI, Standard Tire: P195/65 R15)
3 min*
1.25 (35 LPM)
14.75 ft. (4.5M)
10 ft. (3.0M)
12 volt accessory power outlet
0–150 PSI (0–10 BAR)
LED
CAUTION: HOT! DO NOT OVER INFLATE. DO NOT HOLD IN HAND WHILE OPERATING.
PLACE INFLATOR ON A HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in “accessory”
or “on” position. Please make sure emergency brake is set and car is in park.
2. ALWAYS ensure the valve connector is fully seated to depress the core of the valve
stem for proper inflation.
3. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
4. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
5. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure
markings. Be careful not to inflate items beyond their capacity.
6. While operating, never block the inflator input or output.
7. Keep inflator out of reach of children.
8. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
To Next Page
Loading...
