Slime 40070 - Operation and Safety; Ventilation and Safe Usage; Technical Specifications; Inflating Tires Step-by-Step

TECH SPECS
TIRE INFLATION TIME
CFM (LPM)
DIAL GAUGE
POWER SOURCE
REPLACEABLE FUSE
120V POWER CORD LENGTH
AIR HOSE LENGTH
* (0-35 PSI, Standard Tire: P195/65 R15)
6 min*
0.75 CFM (21.2 LPM) @ 0 PSI
PSI 0-60, BAR 0-4
120V plug into wall outlet
2A 250V 5mm x 20mm
6 . (1.82 m)
20 . (6.1 m)
Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A CONFINED
AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death could occur. Always
operate the inflator in a well-ventilated area free of combustible materials, gasoline, or solvent
vapors. Always set parking/emergency brake and ensure vehicle is in Park (or neutral if equipped
with manual transmission.)
• Do not aempt to disassemble inator.
• No user serviceable parts inside. The only user serviceable part is replaceable fuse.
• Keep inator out of reach of children.
• Ensure air hose chuck touches the core of the valve stem for proper ination.
• DO NOT use inator continuously for more than 6 minutes. Allow unit to cool approximately 20 minutes
between uses. Do not leave inator unaended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inate.
• So inatables (i.e. ras, balls, etc.) may not have recommended pressure markings. Be careful not to inate
items beyond their capacity.
• While operating, never block the inator input or output.
WARNING
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
INFLATE TIRES
1. Make sure the power cord is plugged into a 120 volt wall power outlet.
2. Place hose connector on air valve stem and push down thumb latch to lock onto valve.
3. Press power button on inflator to turn on. Inflate tire to manufacturer’s recommended
air pressure. Correct tire pressure can be found in vehicle owner’s manual or on driver’s
side door jamb. When desired pressure is reached, turn off inflator.
1
2
3
1. Make sure the power cord is
plugged into a 120 volt wall
power outlet.
2. Place hose connector on air
valve stem and push down
thumb latch to lock onto valve.
show #2 as being put onto the
valve stem and the pushing
the lever down to lock(arrow?)
3.Press power button on
inflator to turn on.