SMA STP 15000TL-30 - Page 4

7.2 Configuring the Country Data Set.................................................... 31
7.3 Commissioning the Inverter............................................................... 32
8 Configuration............................................................................ 35
8.1 Configuration Procedure................................................................... 35
8.2 Integrating the Inverter into the Network ......................................... 35
8.3 Changing Operating Parameters ..................................................... 36
8.4 Setting the Active Power Limitation in case of PV System Control
Failure................................................................................................. 36
8.5 Configuring the Modbus Function.................................................... 37
8.6 Reducing the Attenuation of Ripple Control Signals ....................... 37
8.7 Setting SMA OptiTrac Global Peak................................................. 38
9 Operation ................................................................................. 39
9.1 LED Signals ........................................................................................ 39
9.2 Display Overview.............................................................................. 39
9.3 Activating and Operating the Display ............................................. 41
9.4 Calling Up Display Messages of the Start-Up Phase...................... 42
10 Disconnecting the Inverter from Voltage Sources ................. 43
11 Technical Data .......................................................................... 46
12 Accessories ............................................................................... 51
13 Contact ...................................................................................... 52
14 EU Declaration of Conformity ................................................. 54
Table of Contents
SMA Solar Technology AG
Operating ManualSTP15-25TL-30-BE-en-134