1382 mm
2224 mm
530 mm
50 mm
400 mm
190 mm
315 mm
415 mm
438 mm
415 mm
940 mm
Figure 5: Recommended clearances
5.2 Mounting the Inverter
Additionally required mounting material (not included in the scope of delivery):
☐ At least two screws suitable for the support surface (diameter: 10mm at maximum)
☐ At least two washers that are suitable for the screws (diameter: 30mm at maximum)
☐ If necessary, two screw anchors suitable for the support surface and the screws
☐ For transporting the inverter with a crane: two eye bolts suitable for the weight of the inverter
(size: M10)
☐ To secure the inverter from being lifted off: two screws suitable for the support surface, two
washers suitable for the screws and - depending on the support surface - two screw anchors
suitable for the support surface and the screws
5 Mounting
SMA Solar Technology AG
Operating ManualSTP15-25TL-30-BE-en-1318
To Next Page
Loading...
