SMA STP 25000TL-30 - Safety Information; Ec Declaration of Conformity

STP20-25TL-IS-xx-10
5
ENGLISH
SAFETY INFORMATION
DANGER TO LIFE DUE TO ELECTRIC SHOCK
When exposed to sunlight, the PV array generates dangerous DC voltage which is present in the DC
conductors and the live components of the inverter. Touching the DC conductors or the live components can
lead to lethal electric shocks. If you disconnect the DC connectors from the inverter under load, an electric arc
may occur leading to electric shock and burns.
This manual is intended only for electrically quali󹻭ed persons trained in the installation and commissioning of
electrical devices and installations and experienced in mounting and commissioning PV systems. You will 󹻭nd a
detailed operating manual at www.SMA-Solar.com.
• Work on the inverter must only be performed by electrically quali󹻭ed persons.
• Do not touch the DC conductors or any other uninsulated conductors.
• Do not open the upper enclosure lid.
• Disconnect the inverter from all voltage sources before working on the inverter or the PV array:
3
L1L2 L3 N
4
DANGER: Only after step 4 and observance of the 20 minute waiting time is the inverter voltage-
free.
INSTALLATION MANUAL  Page 28
Perform the following actions in the speci󹻭ed order and observe all information.
You will 󹻭nd a detailed operating manual for commissioning and a service manual for troubleshooting
at www.SMA-Solar.com.
EC DECLARATION OF CONFORMITY
within the scope of the EC directives
• 2004/108/EC (electromagnetic compatibility, EMC)
• 2006/95/EC (Low voltage, LVD)
SMA Solar Technology AG con󹻭rms herewith that the inverters described in this document are in compliance with
the fundamental requirements and other relevant provisions of the above mentioned directives. The complete EC
Declaration of Conformity can be found at www.SMA-Solar.com.