SB30_50TL_21-BA-BEN113410 | IMEN-SBXTL-21 | Version 1.0 EN
PV Inverters
SUNNY BOY 3000TL/4000TL/5000TL
User manual
AC
Abbreviationfor "alternating current".
Bluetooth
Bluetooth is a radio technology that allows the inverterand other communication devices to
communicate with each other. Bluetooth communication does not require visual contact between the
devices.
DC
Abbreviation for "direct current".
Electronic Solar Switch (ESS)
The Electronic Solar Switch is part of the inverter DC disconnection unit. Electronic Solar Switch must
be securely inserted into the bottom of the inverter and must
only be removed by electrically qualied persons.
PV
Abbreviation for photovoltaics.
Visual inspection
Check the inverter and cables for any signs of external damage. Contact your installer if you nd any
damage. Do not perform any repair work yourself.
Maintenance and Cleaning
Ask your installer to check for correct inverter operation at regular intervals.
If the display eld or the LEDs are dirty and you nd it dicult to read the operating data and
operating states of the inverter, clean the display and the LEDs with a damp cloth. Do not use any
corrosive substances (e.g. solvents, abrasives) for cleaning.
VISUAL INSPECTION, MAINTENANCE AND CLEANING
Symbole am Wechselrichter
Operation display
Bluetooth
®
. Bluetooth
communication active.*
An error has occurred. Inform your installer immediately.
There are special requirements for the grounding.
Symbole auf dem Typenschild
Beware of dangerous electrical voltage.
The inverter operates at high voltages. Any work on the inverter must be carried
out by electrically qualied persons only.
Beware of hot surface.
The inverter can become hot during operation. Avoid contact during operation.
Observe enclosed documentation.
The inverter must not be disposed of together with the household waste.
Further disposal information can be found in the enclosed installation manual.
CE mark. The inverter complies with the requirements of the applicable EC
guidelines.
Device class label The inverter is equipped with a wireless component that
complies with the harmonized standards.
Certied safety The inverter complies with the requirements of the Europe
Equipment and Product Safety Act.
RAL quality mark for solar products The inverter complies with the requirements of
the German Institute for Quality Assurance and Labeling.
In compliance with Australian mark
Direct current (DC)
Alternating current (AC)
The inverter is protected against penetration by dust particles and water jets from
any angle.
The inverter is transformerless.
* The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of these marks by SMA Solar Technology AG is under license.
EXPLANATION OF SYMBOLS
GLOSSARY
Installer contact
CONTACT
If you have technical problems, contact your installer. The following information is required in
order to provide you with the necessary assistance:
• Inverter device type
• Inverter serial number
• Type and number of PV modules connected
• Event number or display message on the inverter
• Optional equipment (e.g. communication products)
SMA Solar Technology AG
Sonnenallee 1
34266 Niestetal, Germany
www.SMA.de
SMA Service Line
Inverters: +49 561 9522 1499
Communication: +49 561 9522 2499
Fax: +49 561 9522-4699
E-mail: Serviceline@SMA.de
To Next Page
Need help?
General
