Smart Flex SF-1000 - Remote Control Operation; Preset Positions and Memory

14
Pairing the Remote Control to the Control Box
As the pairing procedure is already done by the manufacturer, you
can just insert 2 AAA batteries into your wireless remote control and
start to enjoy your SF-1000 Adjustable Bed. If your remote control fails
to operate, please refer to troubleshooting #8.
Wireless Remote Control Operation
1. Press 1 once to preset Zero G position (Head Approx. 20
degrees, Foot Approx.40 degrees)
2. Pair Button to pair your remote and bed in case they become
unpaired (see troubleshooting#8)
3. Press 4 once to preset TV position (Head Approx. 65 degrees,
Foot Approx. 15 degrees)
4. Memory Button is used to set your desired position. Adjust your
bed to the desired positions, then press and hold the Memory
button for 8 seconds until the Timer LEDs flash. Your Memory
button is now set. Press once to use your memorized position.
5. Press to turn on/off under bed lightning
6. Press and Hold for to turn on light.
7. Press and Hold for to raise foot of the bed.
8. Press and Hold to raise Head A of the bed.
9. Press and Hold to raise Head B of the bed.