10!14 Helpful hints
Breakdown set*
>Note!
If a pressure of 1.8 bar cannot be
generated, disconnect the compressor
from the wheel. Carefully drive the car
10 meters forward or backward to
distribute the tyre sealant in the tyre.
Inflate the tyre again.
! Continue your journey immediately
after removing the compressor, so that
the tyre sealant is distributed evenly
around the tyre's interior and can seal
the damaged point.
! After driving for about ten minutes,
check the pressure with the gauge on
the compressor.
>Important!
The compressor (yellow box) must be
placed back in the footrest right after
use, as it forms the footrest area for the
passenger.
Accident risk!
If the tyre pressure of 1.8 bar
cannot be achieved after five minutes,
the tyre is damaged too severely.
Do not drive any further! Air could
otherwise escape from the tyre. You
could cause an accident as a result.
Notify a qualified specialist
workshop, e.g. a smart center.
Accident risk!
Do not exceed a speed of 80 km/h
or 50 mph when you have repaired a tyre
with the tyre sealant.
The "max. 80 km/h" must be displayed
on the instrument panel within the
driver's field of view.
Your car's handling characteristics
may be impaired by the damaged tyre
even if it has been repaired using the
tyre sealant.
Accident risk!
If the tyre pressure has fallen
below 1.3 bar, the tyre is too badly
damaged.
Do not drive any further! Air could
otherwise escape from the tyre. You
could cause an accident as a result.
Notify a qualified specialist
workshop, e.g. a smart center.
!"#$%&'()*$#+,,-#.#/01,,2034567(809:;<%%=##>*7)*#?C##@%4)&5A#-1;#B=)%<*$#-,,C##??DC?#??
To Next Page
Loading...
