3!16 Adjustments
Car cover*
Car cover*
Do not use the car cover to conceal
extremely dirty vehicles, as the dirt
particles will act like sandpaper on the
paintwork.
>Important!
If the vehicle is to be continually
covered up for longer than a month, the
roof, engine compartment and luggage
compartment areas must be ventilated at
those areas where the car cover makes
contact with a large surface.
The vehicle’s paintwork may absorb
moisture, which has to be released. If the
absorbed moisture is not released again,
blotches may form on the paintwork.
In order to prevent such stains from
forming, spacers – made, e.g. from
expanded polystyrene – should be
inserted between the car cover and the
vehicle surface to ensure that sufficient
air can circulate.
Fitting the car cover
The car cover has been folded ex works so
that when it is unrolled, the material’s
foam!based side always faces the
bodywork.
! Roll the car cover over the vehicle roof
from the rear to the front.
! Unfold the car cover on both sides.
! Pull the cord tight so that the cover has
a taut fit.
>The wind now cannot lift up the car
cover.
!"#$%&'()*$#+,,-#.#/01,,2034567(809:;<%%=##>*7)*#?F##@%4)&5A#-1;#B=)%<*$#-,,C##??DC?#??
To Next Page
Loading...
