SMART RSM950 - Helpful Tips; Cleaning & Maintenance

ENGLISH
7
HELPFUL TIPS
• Add more liquid to Blending Chamber if vacuum occurs around Cylinder during use.
• Blending Chamber must be rmly attached to Base or unit will not turn on.
• A towel placed under your SMART 5-IN-1, will help with clean-up. You should expect some
dripping.
• DO NOT store slush drinks in freezer or fridge. They should be consumed immediately.
• REMINDER: 32 ounces (2 pounds) of liquid does not produce 32 ounces of slush. You are
creating slush and the liquid has solidied into ice. Likewise, creating slushy ice cream
incorporates air into the mixture, causing it to expand. If ice cream mixture runs over into
canister, dispense some of the mixture to lower the level in the unit.
• If making another batch, remove Aluminum Cylinder and rell with ice and salt layers.
Liquids
• Drinks with a high sugar or corn syrup base will crystallize faster and produce a thicker slush
than those with milk or lower sugar content. Carbonated drinks will set up slower and will
not be as thick.
• We recommend adding pre-chilled liquid to your SMART 5-IN-1. This will quicken the slush making
process.
• Carbonated diet drinks and alcoholic beverages will not slush. DO NOT add alcohol
until the slush is poured into glasses.
• DO NOT use sti mixtures such as whipped or whipping cream or frozen liquids; this will
cause stress on the unit's motor.
• NOTE: If mixture gets too thick, or does not dispense well, add more liquid to the mixing
chamber opening.
Mixture is Not Freezing
• Possible reasons for mixture not chilling or freezing:
1. The Aluminium Cylinder was not cold enough. Try adding more ice and salt. Salt is a
critical part of the freezing process and you will need plenty of salt added to the ice for the
slush to freeze properly.
2. The mixture was too warm.
3. Alcohol was added to the mixture. DO NOT add alcohol until the slush is poured into
glasses.
CLEANING & MAINTENANCE
1. After using your SMART 5-IN-1, disconnect from electrical outlet. Remove plug by gripping
the plug body and pulling out of the outlet. Never yank or twist cord to unplug the unit.
2. Thoroughly wash the Blending Chamber, Aluminium Cylinder, Cylinder Cage, Mixing
Mechanism, Lid and Drip Tray in warm, sudsy water and thoroughly dry. DO NOT put the
Base in water. When needed, use a damp, non-abrasive cloth to wipe exterior and then dry
thoroughly.
3. NEVER immerse Base in water or put any parts in the dishwasher.
RSM950_ENG_IM_2017_v3.indd 7 07/03/2018 11:28