Steering
Chassis
81
Introduction of the smart fortwo, Model Series 451
Steering wheel removal and installation
The following components of the steering wheel are
replaceable:
• Contact unit with steering angle sensor
• Airbag module
• Paddle shifts (three-spoke sport steering wheel
only)
The steering wheel must be detached first before
replacing or removing/installing any of the above
components.
Care must be taken to ensure that the front wheels are
in the straightahead position, the battery is discon-
nected and the handbrake is applied before the
steering wheel is removed.
The exact procedure for removal/installation of the
steering wheel and its components is described in the
Workshop Information System (WIS).
i Note
All control units must be de-energized before the
steering wheel is removed. For this reason, at
least 15 minutes must elapse after the battery is
disconnected before it is removed.
i Note
Care must be taken to ensure that the turn signal
is not set when removing/installing the steering
wheel otherwise the trigger tab may be damaged.
P46.10-2841-00
SN_Typ 451_us.book Seite 81 Freitag, 30. November 2007 1:56 13
To Next Page
Loading...
