To Next PageTo Next Page
Need help?Do you have a question about the SMART Watchdog and is the answer not in the manual?
General| Brand | SMART |
|---|---|
| Model | Watchdog |
| Category | Control Panel |
| Language | English |
Details the micro-controller based indicator panel that monitors show status for multiple cinemas.
Determine mounting locations, install enclosures, and connect 120 VAC service to the unit.
Set panel options using DIP switches for Master/Slave mode, alarm timer, mounting orientation, and data format.
Provides specific instructions for connecting Watchdog Panels with a Panalogic Automation System.
Connect the provided power pack plug to J1 and then into the AC outlet within the enclosure.
Choose between horizontal and vertical front panels; exchange them if vertical mounting is required.
Dress internal wires and secure the front panel/PC board assembly to the metal enclosure using thumb screws.
Minimize total wiring length to prevent signal degradation; use 4-conductor cable, cut off shield.
