09
USER MANUAL: SF500
Control Box Pairing Mode
First, on your SF500 control box, press and hold the
Link Button for a few seconds and release. You will
know your control box is in pairing mode when the
Link LED beside of the Link button starts blinking.
Remote Control Pairing Mode
Next on your SF500 remote, hold down the Head
Up and Foot Up buttons together for a few seconds
and release. If done correctly the remote’s back light
starts ashing blue.
Test and Confirm
If done correctly the Link LED on the control box
and the back light on the remote will stop ashing
immediately. Test the features of the bed by using
the remote to conrm the pairing’s success. If the
remote can operate any function of the bed you will
know the remote is paired correctly. If the remote
can operate a feature of the bed but not another
that is a good indicator that the feature the remote
can not operate is not functioning properly and you
should contact customer service. If the remote is still
not operating the base repeat the above steps.
Pairing Your Remote
To Next Page
Loading...