smartmicro UMRR-0C Type 42 - 6 Cables and Connectors; Sensor Connector

CONFIDENTIAL AND PROPRIETARY
The Information contained in this document shall remain the sole exclusive property of s.m.s, smart microwave sensors GmbH and shall not
be disclosed by the recipient to third parties without prior consent of s.m.s, smart microwave sensors GmbH in writing.
UMRR-0C Type 42 User Manual USA-Canada_100MHz.docx Version 2 I Page 10 of 19 I November 22, 2017
6 Cables and connectors
6.1 Sensor connector
The used sensor connector is a 12-pin male (plug) circular bayonet type connector (water
proof IP67, series LF10WBRB-12PD, manufacturer Hirose, Japan). A female counterpart
(socket)e.g. LF10WBP-12S has to be used to connect to the sensor. The pin numbering of the
socket is shown in Figure 4 together with the pin description is given in Table 2: Sensor
Connector pin out Model UMRR-0C
Figure 4: Sensor connector pin out Model UMRR-0C
Table 2: Sensor Connector pin out Model UMRR-0C
Pin
Signal name
Wire Pair
Function
1
Eth_Tx1_P
1
Ethernet – RJ45 Pin 1
2
Eth_Tx1_N
Ethernet – RJ45 Pin 2
3
RS485_IN_N
2
RS485 Input
4
RS485_IN_P
5
RS485_OUT_N
3
RS485 Output
6
RS485_OUT_P
7
GND
4
Ground
8
Vcc
13 .. 32 V DC Supply
9
Eth_Tx2_N
5
Ethernet – RJ45 Pin 6
10
Eth_Tx2_P
Ethernet – RJ45 Pin 3
11
CAN Hi
6
CAN Interface
12
CAN Lo