Your display is easily controlled with 3 buttons located
on your handlebars
Walk Mode
Press and hold down for 2 seconds to enter into
the mode of power assist walk. The bike will go on
at a uniform speed of 6km/h and display 6km on
the screen.
Power On/Off
Press and hold for 3 seconds to start the
display and power up the bike. To turn off, press
and hold the button for 3 seconds.
Note: the display will power off after 5 minutes
without use.
Change mode
Touch to change modes.
Pedal Assist
Pedal Assist is controlled with the
buttons. Touch to turn the assist up, and
touch to turn it down.
Lights/Night Mode
With the display on, press and hold for 3
seconds to activate Night Mode. This will ip the
contrast colours of the LCD screen making it easier
to read in the dark. For the Pacer the lights will also
turn on. Press and hold again to turn off the
bicycle lights.
Setup
Press and hold together for 5 seconds to
enter the setup menu.
Touch to select the menu.
Use and to change the value.
Touch again to choose the “Save & Exit” option
to nish the setup.
7. LCD Display Panel Controls 7. LCD Display Panel Controls
Sleep Mode
If the bike remains stationary for 5 minutes, the LCD
automatically powers down.
USB Output Charging
User can charge phone, etc, via the USB output port
which is located above of the LCD, under a rubber
waterproof plug. As long as the battery is attached
the port is live. Make sure the plug is reinstalled
after charging.
Error Code Display
If there is something wrong with the electronic
control system, the display will show the error code
automatically. Should you receive an error code,
contact your local dealer for advice.
Before contacting service center check all plugs for
loose connections.
Sports user manual.indd 22-23 7/15/2016 5:00:13 PM
To Next Page
Loading...
