ERROR REASON(S) SUGGESTION(S)
DEAD IN WATER
OUTLET/GFI CHECK OUTLET/RESET THE GFI OR TRY ANOTHER OUTLET
CLEANER RESET UNPLUG THE CLEANER AND ALLOW IT TO REST FOR 30 SECONDS
EXTENSION CORD TRY PLUGGING THE POWER SUPPLY DIRECTLY INTO AN OUTLET
NOT MOVING
DEBRIS CAUGHT IN TRACKS/BRUSHES/IMPELLER CHECK FOR DEBRIS AND CLEAN WITH A GARDEN HOSE/MAY HAVE TO REMOVE IMPELLER CAP (1 SCREW)
CLEANER CAUGHT ON OBSTRUCTION IN POOL TURN THE CLEANER OFF AND GENTLY PULL ON THE CORD TO REMOVE IT FROM OBSTRUCTION
FILTER BAG INSTALLATION RUN THE CLEANER WITHOUT THE FILTER BAG AND CHECK THE BOTTOM LID/FILTER BAG FOR PROPER INSTALLATION
TRACKS FELL OFF CHECK TO SEE IF THE TRACKS ARE LOOSE OR HAVE FALLEN OFF COMPLETELY
NO SUCTION
FILTER BAG INSTALLATION RUN THE CLEANER WITHOUT THE FILTER BAG AND CHECK THE BOTTOM LID/FILTER BAG FOR PROPER INSTALLATION
FILTERBAG FULL CLEAN THE FILTER BAG THROUGHLY WITH A GARDEN HOSE
DEBRIS IN FAN/IMPELLER CHECK FOR DEBRIS AND CLEAN WITH A GARDEN HOSE/MAY HAVE TO REMOVE IMPELLER CAP (1 SCREW)
STARTS AND STOPS
FILTER BAG INSTALLATION RUN THE CLEANER WITHOUT THE FILTER BAG AND CHECK THE BOTTOM LID/FILTER BAG FOR PROPER INSTALLATION
FILTERBAG FULL CLEAN THE FILTER BAG THROUGHLY WITH A GARDEN HOSE
DEBRIS CAUGHT IN TRACKS/BRUSHES/IMPELLER CHECK FOR DEBRIS AND CLEAN WITH A GARDEN HOSE/MAY HAVE TO REMOVE IMPELLER CAP (1 SCREW)
BRUSHES WORN CHECK THE BRUSHES AND RING (IF APPLICABLE) FOR WEAR/HOLES WHICH WILL INHIBIT THE CLEANER'S PERFORMANCE
CAUGHT ON SOMETHING IN POOL TURN THE CLEANER OFF AND GENTLY PULL ON THE CORD TO REMOVE IT FROM OBSTRUCTION
BACK &
FORTH/DOING
WHEELIES OR SPIN-
NING IN CIRCLES
FILTER BAG INSTALLATION RUN THE CLEANER WITHOUT THE FILTER BAG AND CHECK THE BOTTOM LID/FILTER BAG FOR PROPER INSTALLATION
DEBRIS CAUGHT IN TRACKS/BRUSHES/IMPELLER CHECK FOR DEBRIS AND CLEAN WITH A GARDEN HOSE/MAY HAVE TO REMOVE IMPELLER CAP (1 SCREW)
CLEANER CAUGHT ON OBSTRUCTION IN POOL TURN THE CLEANER OFF AND GENTLY PULL ON THE CORD TO REMOVE IT FROM OBSTRUCTION
TRACKS FELL OFF CHECK TO SEE IF THE TRACKS ARE LOOSE OR HAVE FALLEN OFF COMPLETELY
NOT CLIMBING
FILTER BAG INSTALLATION RUN THE CLEANER WITHOUT THE FILTER BAG AND CHECK THE BOTTOM LID/FILTER BAG FOR PROPER INSTALLATION
DEBRIS CAUGHT IN TRACKS/BRUSHES/IMPELLER CHECK FOR DEBRIS AND CLEAN WITH A GARDEN HOSE/MAY HAVE TO REMOVE IMPELLER CAP (1 SCREW)
FILTER BAG FULL CLEAN THE FILTER BAG THROUGHLY WITH A GARDEN HOSE
BRUSHES WORN CHECK THE BRUSHES AND RING (IF APPLICABLE) FOR WEAR/HOLES WHICH WILL INHIBIT THE CLEANER'S PERFORMANCE
POOL CHEMISTRY (ALGAE GROWTH) HAVE THE WATER CHECKED BY A POOL PROFFESSIONAL AND/OR BRUSH THE POOL WALLS
CORD TANGLING
UNIT NOT BEING UNPLUGGED FROM POWER SUP-
PLY REGULARLY
MAKE SURE THE CABLE IS BEING UNPLUGGED FROM THE POWER SUPPLY AFTER EVERY 1-2 CYCLES TO RELEASE THE TEN-
SION THAT BUILDS DURING A CYCLE
EXCESS CORD IN POOL ONLY USE THE NECESSARY AMOUNT OF CABLE TO COVER THE POOL EFFICENTLY
CORD NOT BEING UNWOUND BEFORE USE
MAKE SURE THE CABLE IS STRAIGHTENED OUT BEFORE THE CYCLE IS STARTED/WALK THE CLEANER THE LENGTH OF THE
POOL TO STRAIGHTED CORD
CORD BEING WRAPPED/STORED INCORRECTLY
WHEN WRAPPING THE CABLE, MAKE LARGE LOOPS AND START AT THE CLEANER END SO THE FREE, PLUG END CAN UN-
WIND ANY RESIDUAL TENSION
UNIT FLOATING
AIR TRAPPED IN FILTER BAG ROCK THE CLEANER BACK AND FORTH UNDER WATER TO RELEASE ANY TRAPPED AIR
CLEANER CLIMBING TOO HIGH REGULARLY
A WEIGHT CAN BE ADDED TO THE CLEANER TO PREVENT IT FROM CLIMBING TOO HIGH AND TO ASSIST IN THE DECENT
BACK TO THE FLOOR
D.E. PRESENT IN FILTERBAG IF THERE IS D.E. IN THE POOL, IT COULD CLOG THE BAG. CLEAN THE BAG THOROUGHLY
RCU NOT WORKING
BATTERIES DEAD MAKE SURE BATTERIES ARE IN GOOD WORKING CONDITION
OUT OF RANGE/OBSTACLE INTERFERANCE MAX RANGE IS ABOUT 100 FEET AND OBSTACLES (ELECTRICAL EQUIPMENT) MAY INTERFERE WITH THE SIGNAL
REMOTE DROPPED OR FELL IN POOL
IF THE REMOTE IS DROPPED OR SUMERGED IN WATER FOR AN EXTENDED PERIOD OF TIME IT MAY AFFECT THE PERFORM-
ANCE
ADMIRAL TROUBLE SHOOTING GUIDE
To Next Page
Loading...