w w w . s m a r t p o o l . c o m
9
1) Place the cleaner on the bench and
examine for physical damage and for any
debris caught in the impeller or drive
brushes (remove debris if found).
2) Place the cleaner upside down on bench
and remove the Bottom Lid by pushing in
on the red tabs.
3) Perform a Self Test: Plug Cable into the
Power Supply and turn to the ON position.
Important: The Pump Motor will engage
but the Drive Motor will not (An Air Flow
Sensor in the Pump Motor prevents the
Drive Motor from operating out of water).
To Next Page
Loading...