EasyManua.ls Logo

SmartPool Nitro User Manual

Default Icon
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
NITRO ROBOTIC POOL CLEANER OPERATION MANUAL
Congratulations on your purchase of the most technologically advanced automatic pool
vacuum available today. The Nitro is easy to use and will make maintaining your pool
affordable and effortless. Following these simple directions will insure that the Nitro will
quickly and efficiently clean your pool today and for many years to come.
INSTALLATION
Place the power supply in an area that will allow the cleaner to cover all areas of the pool.
Be sure to only plug the power supply into a GFI (ground fault interrupter) or ELI (earth leak interrupter) protected electrical outlet.
Look at the power supply and check that the power supply switch is in the off position.
Plug the power supply into the protected outlet.
Plug in the connector from the cleaner into the power supply. The connector is keyed so that it will only plug into the power supply one way.
Make sure that the plug is pushed all the way onto the power supply. Slide the connector lock (strain relief) onto the connector and turn
the connector lock clockwise until it is snug.
DO NOT RUN THE CLEANER OUT OF THE WATER.
OPERATING THE CLEANER OUT OF THE WATER WILL DAMAGE THE MOTORS AND VOID THE WARRANTY
Place the cleaner into the pool and if needed rock the cleaner side to side to release any trapped air. The cleaner will sink to the bottom of the pool.
Put enough of the blue cord into the water to assure that the cleaner can easily reach all areas of the pool.
Turn the switch on the power supply to the on position.
The cleaner will begin its cleaning program.
The cleaner will automatically shut itself down after two hours.
If a second cleaning is required or the unit is accidentally shut off, you should wait one minute before switching the unit on again.
IMPORTANT NOTE: During normal operation, the cleaner will appear to shut off for a few seconds, raise the
front wheels off the pool bottom and move either left or right or turn for an undetermined amount of time. This is
normal and has been preprogrammed into the unit to assure the quickest and most efficient cleaning of your pool.
Question and Answer IconNeed help?

Do you have a question about the SmartPool Nitro and is the answer not in the manual?

SmartPool Nitro Specifications

General IconGeneral
BrandSmartPool
ModelNitro
CategorySwimming Pool Vacuum
LanguageEnglish

Summary

Installation Guide

Removing Cleaner From Pool

Filter Bag Maintenance

Cable Maintenance

Storing the Cable

Guidelines for properly coiling and storing the cleaner's power cable to maintain its form.

Winter Storage

Troubleshooting Guide

Related product manuals