What to do if my SmartPool Scrubber60 Swimming Pool Vacuum is not covering all areas of the pool?
If your Scrubber60 isn't reaching all areas, reposition the power supply so the cleaner can access all walls. Ensure the pool filter pump is off. If the floor and walls are too slick, brush them down. Uncoil the cord if there's excessive coiling. Lastly, check the tracks for any debris and clear it out.
Why is my SmartPool Swimming Pool Vacuum cord twisting?
Cord twisting can occur due to several reasons. There might be an obstruction in the pool, in which case you should remove it. Also, ensure that only enough cord is placed in the pool for the cleaner to reach the bottom, allowing the cleaner to pull in the extra cord when needed. Excessive coiling can also cause twisting, so uncoil the cord. Finally, make sure to disconnect the cord from the power supply after each use to alleviate any tension.
General| Brand | SmartPool |
|---|---|
| Model | SCRUBBER 60 |
| Category | Swimming Pool Vacuum |
| Language | English |
Essential safety precautions and warnings for operating the robotic pool cleaner.
Instructions for connecting the power supply to a protected electrical outlet.
Critical warnings and notes for proper use, including not running out of water.
Steps for safely retrieving the robotic cleaner from the swimming pool.
Step-by-step instructions for removing and cleaning the filter bag after each use.
Guidance on maintaining and uncoiling the power cord for proper function.
Guidelines for storing the cleaner and power supply during cold weather conditions.
Guide to diagnosing and resolving common operational problems with the pool cleaner.
Details the warranty period, exclusions, and limitations for the pool cleaner.
Warning about potential wear or damage to pool liners caused by the cleaner.
To Next Page
