7
The unit should be stored in an area that will afford some protection from the elements to
insure that it retains its finish
. DO NOT STORE NEAR OPEN CHEMICALS
• To reapply the filter bag, first turn it right side out. Next place the filter bag frame onto
the bottom lid being sure that the bag frame seats fully into the channel. Press down
on all corners to ensure fit. Check the seat of the filter onto the bottom lid (see Figure 7)
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
• Pick up the bottom lid and turn it over so the bag hangs below it (see Figure 8). Place
the bottom lid back into the cleaner being careful to feed the filter bag into the body of
t he cleaner. MAKE SURE ALL FILTER MATERIAL IS INSIDE THE CLEANER
OTHERWISE THE LID WILL NOT CLOSE AND LATCH PROPERLY.
• Once the bottom lid is seated press it firmly into the cleaner. Gently pull on the bottom
lid to insure that it is properly locked in. The lid is now installed.
CABLE MAINTENANCE
UNCOILING THE CABLE
STORING THE CABLE
• Loosely loop the cable as shown in Figure 10.
• Unplug the cable from the power
supply.
• Hold the cord close to the cleaner.
• Make a roughly two foot loop with
the cord as shown.
• When making loop, roll the cable
slightly in a counter clockwise
manner to maintain form.
DO NOT WRAP THE CORD
TIGHTLY AROUND OBJECTS.
STORAGE
WINTER
SUMMER
If temperatures will regularly be below 45 degrees Fahrenheit or 5 degrees Celsius, the
cleaner and power supply should be stored indoors.
In the event that the cable does coil on itself, it can easily be straightened by following the below
instructions.
• Turn the power supply to the off position
• Remove the cleaner from the pool and place it on the far end of the pool deck/yard
(away from the power supply)
• Unscrew the blue cable from the power supply
• Hold the black collar at the plug end and gently lift the cable off the ground (FIGURE 9)
• Gently pull on the cable to straighten
• The swivel will rotate as tension is applied, eliminating the coils in the cable
• Return to normal cleaner use
To Next Page
Loading...
