Complete a Walk Test
Once you’ve nished setting up your ADT Security Hub and
detectors, you should perform a Walk Test to ensure that all
your devices are installed and working correctly.
1.
2.
3.
4.
Select System Settings from the Home screen on your
ADT Security Hub.
Press and release the button on the top of the detector
twice.
If the ADT Door and Window Detector did not pair
successfully with the ADT Security Hub, follow these
instructions to reset it:
Enter the Master User Code.
Press and hold the button. The red LED will begin to blink
quickly, and after a short period of time it will stay on.
Release the button and after 5 seconds the red LED will
begin to blink slowly.
Use the SmartThings app to complete setup..
If you’re still having trouble connecting the ADT Door and
Window Detector, please visit SmartThings.com/Support-ADT for
assistance.
Select Walk Test.
Select Sensors Test and follow the on-screen instructions.
Select Console Test and follow the on-screen instructions.
Tap or the Home button to exit Test Mode.
Note: It is strongly recommended that you repeat this Walk
Test on a monthly basis.
• If a detector fails the Sensors Test, check that it’s
been installed correctly or visit SmartThings.com/
Support-ADT for assistance.
Troubleshooting
E
To Next Page
Loading...