16 GB
Select „More“ and enter the default Admin password „123456“.
Click „OK“ to confirm.
Opening „More“ for the first time will open a window prompting
you to enter a new Admin password. You will need to enter a new
password or you will be unable to access the settings. To change
the password again later, scroll all the way up in the „Adv. Set-
tings“ menu until you see the item „Admin Password“. Then enter
your old password, followed by the new one. Enter it again to
confirm the new password.
Scroll down until you see the field „Security Code“. Select „Change“.
Enter the default old password („123456“) and select a new
password and repeat to confirm your entry. Click „OK“ to confirm
your entry.
Scroll down until you see the „WLAN Config.“ field. Select „Adv.
WLAN network“ (see Fig. G).
Once you have successfully entered your WLAN password the
camera will restart. Please disconnect the network plug from the
router when restarting.
The security code allows you to access the camera („Live View“,
not for changing settings) and the „Admin Password“ is used to
change any camera settings.
IMPORTANT: The camera software requires two passwords – the
security code for accessing the camera, and the admin password for
configuring the camera.The factory setting for both passwords is
„123456“. After changing the passwords the new passwords must be
used, not the default password. Please remember the passwords.
Be sure to change both passwords to prevent unauthorised access
to the camera.
To Next Page
Loading...
Need help?
General
