Smartwares SHS-51001-EU - What You will You Find in the Box of Your Set; Intended Use; Installation

Installation instructions – wireless door activated light switch 19
Installation
Placing the wireless switchable lamp socket in a lamp
1. Turn off the switch of the lamp.
2. Unplug the lamp from the socket. Has the lamp got no
plug? Switch off the power at the main switch in your
meter cupboard.
3. Screw in a bulb into the wireless switchable lamp
socket. Make sure that you use a lamp with the correct
specications.
4. Screw the wireless switchable lamp socket on the E27
ttingofthelamp.
5. Insert the plug of the lamp back in the socket or switch
the power on at the meter cupboard.
6. Turn on the switch of the lamp again.
The red LED of the wireless switchable lamp socket
goes on.
Activating the magnetic contact (rst time use)
The magnetic contact is provided with a battery.
Activate the battery by pulling the plastic tab from the contact sensor. This is only
necessarywhenusedthersttime.
What you will you nd in the box of your
set?
1. One E27 wireless switchable lamp socket
2. One magnetic contact
Intended use
The set consists of a wireless switchable lamp socket and a magnetic contact. The
magnetic contact is intended to be placed at a door or window inside the house
in such a way that when you open the door or window the magnetic contact is
broken. After the contact has been broken, it transmits a signal. This signal can be
picked up by compatible receivers including the wireless switchable lamp socket
and the HomeWizard.
The wireless switchable lamp assembly needs to be turned into a lamp socket.
The lamp, which had been turned into the wireless switchable lamp socket, can
be switched on and off from a distance.
Any other use than the intended use described above is seen as unintended use.
The manufacturer is not liable for any damage as a result of unintended use.
18 Installation instructions – wireless door activated light switch