Smartwares SHS-51001-EU - Installation and Use Together with the Homewizard

Installation instructions – wireless door activated light switch 21
3. Take the contact sensor and the magnet apart.
4. Check whether the LED on the wireless switchable lamp socket lights up.
Does the LED light up? You have now linked the wireless switchable lamp
socket with the magnetic contact.
Resetting the linkages
To reverse all the prepared linkages, proceed as follows:
1. The red LED of the wireless switchable lamp socket lights up. Check this
out.
2. Keep the programming button pressed for 6 seconds.
TheLEDstartstoash.
3. Pressthebuttonagainbriey.
The LED switches off.
All saved links are removed from the receiver.
Installation and use together with the
HomeWizard
The devices from this set can be used in combination with the HomeWizard. The
HomeWizard does not form part of this set. If you don’t already have a
HomeWizardthenyoumustacquireitrst.Formoreinformation,visit
www.homewizard.nl.
Connecting the magnetic contact with the wireless switchable lamp
socket
Note: make sure that you have installed the wireless lamp socket before you
perform these steps.
To connect the magnetic contact with the wireless switchable lamp socket, do
the following:
1. Place the touch sensor and the magnet against each other.
2. Press the button of the wireless switchable lamp socket for three seconds.
TheLEDwillstartashing.Thewirelessswitchablelampsocketisnowin
connecting mode.
3 sec
NOTE!TheLEDmightashafterrelease.IftheLEDbeginstoashduring
the press action, then it will not be linked.
20 Installation instructions – wireless door activated light switch