17
1. Remove the compartment cover with screws.
2. Insert the Micro SD card.
3. Connect power cable by pressing down the power input I/O pins. After supplied power,
the boot
up process will begin (> 2 minutes), the red/green LED will become steady on
after the boot up process is complete (check connectors and power source if red/green
LED do not come on).
I/O Pin
Power cable
Connector
Memory Card Slot
Compartment Cover
1
2
3
Note: For how to connect VD40W with existing doorbell wires, electronic lock/gate,
please refer to "Additional Wiring Diagram" section.
SETUP THE VD40W
To Next Page
Loading...
