TROUBLE SHOOTING
IF THE SMARTWASHER IS LOW ON FLUID, THE
HEATER AUTOMATICALLY SHUTS OFF.
Check to see if the “Add Fluid” indicators are lit. There
should be approximately 11” (28 cm) of fluid in the
machine when it is low.
If the “Add Fluid” light is lit, add a full container of
OzzyJuice (the light should go out).
Allow for a reasonable warm up period and then
recheck.
Issue - COLD FLUID
Cold OzzyJuice Overheated OzzyJuice
Issue - OVERHEATED FLUID
If the fluid becomes extremely hot and exceeds
120°F (49°C) unplug the SmartWasher and call
customer service at 1-770-564-5580.
The Thermostat is factory-set to maintain the fluid
at 105° F to 115° F (+-2°) ( 40°C or 46°C (+-1°)).
OzzyJuice Discoloration Or Odor Spilled OzzyJuice
Issue - FLUID DISCOLORATION OR ODOR Issue - FLUID SPILLAGE ONTO FLOOR
OzzyJuice may become dark in color due to dyes in
oils or greases removed from dirty parts. This will not
affect its cleaning power. If the fluid should develop a
strong odor, it may be contaminated and you should
call ChemFree Technical Support for assistance in
diagnosing the problem.
OzzyJuice will cause the floor to become
slippery. Use caution when walking in or near
spilled fluid. To clean up an accidental spill of
new, unused fluid simply soak up the solution
with an absorbent material, (or wash spillage
down the nearest sanitary sewer). If the spilled
OzzyJuice has been used, you must dispose of
the spillage in accordance with local regulations.
If left to dry, the fluid will leave a tacky spot on the
floor that when wet, will again become slippery.
CHANGE THE OZZYMAT
™
To maintain the effectiveness and performance of the
OzzyJuice change the OzzyMat once a month.
You may be able to dispose of your used OzzyMat as solid waste or with your other absorbent mats.
CHECK LOCAL REGULATIONS:
ChemFree Technical Support : 770-564-5580 www.chemfree.com
Change The OzzyMat Every 30 Days To Maintain Cleaning Performance
6
r
®
SmartWashe
Ozzy
®
ENGLISH
To Next Page