EasyManua.ls Logo

SmartWasher SW-25 - Page 8

SmartWasher SW-25
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To help monitor and maintain the proper
fluid level, the SmartWasher is equipped
with an “Add Fluid Light”. When the “Add
Fluid” light comes on the heater in the
unit will turn off until an ENTIRE (5)
gallon container of OzzyJuice is added.
The “Add Fluid” light will shut off and the
heater will come back on once the (5)
gallon container of OzzyJuice is added to
the SmartWasher.
WATER, SOLVENT, MINERAL SPIRITS,
GASOLINE OR KEROSENE TO YOUR
SMARTWASHER.
DO NOT ADD
OZZYJUICE
®
Degreasing Solution
The SmartWasher
®
uses a
specially formulated fluid
which provides a combination of excellent
cleaning characteristics, safety and nutri-
tion for the Ozzy
®
microbes. OzzyJuice
®
is
provided in ready-to-use containers.
Slowly pour a full container of OzzyJuice
directly into the SmartWasher sink. The
“Add Fluid” light should go out when you
have completed this process.
ADDING OZZYJUICE
®
Your SmartWasher should be plugged in 24
hours a day, 7 days a week to maintain
optimal temperature.
Depending on the OzzyJuice solution shipped
with your SmartWasher, the thermostat is
factory-set to maintain fluid temperature
between 105° F to 115° F (+/-2°) (40°C to
46°C)(+/-1°). This temperature provides the
optimum condition for effective cleaning and
activity of Ozzy microbes.
The heater will not operate when the fluid level
becomes critically low. Lift the sink and check
your fluid level. When the “Add Fluid Light”
illuminates add 1 (5) gallon container of
OzzyJuice. If, after a reasonable warm-up
period, the fluid temperature seems too hot or
too cold, please refer to the “Troubleshooting”
section on page 6, 7 and page 8.
If the temperature falls below the recom-
mended minimum, the system will still clean,
but remediation of the hydrocarbons by the
Ozzy microbe colony will slow down. How-
ever, the microbes will not die. The Ozzy
colony will become more active when the fluid
temperature reaches the appropriate level.
TEMPERATURE SETTINGS
INSTALLATION AND CARE Cont.
CHANGE THE OZZYMAT
To maintain the effectiveness and performance of the
OzzyJuice change the OzzyMat once a month.
You may be able to dispose of your used OzzyMat as solid waste or with your other absorbent mats.
CHECK LOCAL REGULATIONS:
ChemFree Technical Support : 770-564-5580 www.chemfree.com
Change The OzzyMat Every 30 Days To Maintain Cleaning Performance
2
r
®
SmartWashe
Ozzy
®
Operating Manual
ENGLISH