BACK – Advanced Settings - Virtual Server NEXT - Advanced Settings - Access Control
Advanced Settings - Special Applications
Special Applications is a feature that allows your entire LAN or all the computers
on your network to use the range of ports specified. The Trigger Port is the
outbound port. It is the port through which your program begins communication.
The Public Ports are the inbound ports that are open while your application is
running.
Step 1: Input the outbound data port and then select the type of data that port
uses.
Step 2: The Public Port are the incoming ports that must remain open while your
program is in use.
Step 3: Input the inbound data port and then select the type of data that port uses.
Step 4: Click on the “Enable” check box and then click “Apply” to save the
changes.
Step 5: Once all the settings have taken effect, click “Log Out”.
Figure 1.0
To Next Page
Loading...
