SMCCO02-Z CO Alarm User Guide
Copyright
©
2011 SMC Networks Page 7
All Rights Reserved
I/M SMCWK01-Z rev. 1.0
4/19/11
n
c
B.
(approximately 5 seconds), then
CO02-
perly, you hear 4
sends
ows
ved.
At the panel, exit sensor test mode.
s
/
This
agen
A.
the
C.
D.
n
seconds), then
release the button. The SMCCO02-Z
enters functional gas test mode.
The Power LED blinks once per
second while in this test mode.
E. Apply a UL-approved CO test agent
to the slit as shown in Figure 7
below. When CO is detected, the
SMCCO02-Z activa
The SMCCO02-Z
packets to the co
B. Be sure the green Power LED is
flashing for normal operation.
Set the control panel to sensor test
mode.
Press and hold the Test/Hush butto
until the SMCCO02-Z beeps 3 times
(approximately 10
Ru ning the RF Communication Te
This section provides general guidelines
st
for testing the CO alarm with the panel.
For complete testing details, refer to the
ific panel documentation.
Wait at least 10 min
spe
A. utes after
installing the SMCCO02-Z to test the
CO alarm.
Be sure the green Power LED is
flashing for normal operation.
Set the control panel to sensor test
mode to prevent an alarm signal
from being sent to the central-
monitoring stati
C.
on if you have a
monitored system.
Press and hold the Test/Hush button
D.
until the SMCCO02-Z beeps 2 times
release the button. If the SMC
Z is operating pro
quick beeps. The SMCCO02-Z
the RF test packets after the first
four beeps.
E. The control panel beeps and sh
the number of RF packets recei
F.
Running the CO Inspection and
Functional Gas Test
test should be performed by
qualified service
Thi
technicians only. Re
to the most recent version of NFPA 72
r more information about requirem
fer
0
fo ents
for functional testing of CO alarms
an or your Local Authority Having
Jurisdiction (
d
AHJ).
test requires a canned CO testing
t.
Wait at least 10 minutes after
installing the SMCCO02-Z to test
CO alarm.
tes a CO alarm.
sends RF test
ntrol panel when
ates. the CO alarm activ
To Next Page
Loading...