Regulatory Information
WEEE Directive
2002/96/EC (WEEE directive): Products marked with this
symbol cannot be disposed of as unsorted
municipal waste in the European Union. For
proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info.
RoHs Directive
2002/95/EC RoHS Compliant. This product does not
contain lead, mercury, cadmium, hexavalent chromium,
polybrominated biphenyls (PBB) or polybrominated
depheny ethers (PBDE) in more than the percentage
specified by EU directive 2002/95/EC, except exemptions
stated in EU directive 2002/95/EC annex.
UL Rating
ANSI/UL 639 Recognized
ETL Rating
UL 639
FCC Compliance
FCC ID: QPY-5845GB-Z
IC: 8303B-5845GBZ
The device complies with part 15 of the FCC Rules as
well as Industry Canada Rules and Regulations license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept
any interference received, including interference that
may cause undesired operation.
Conformité Réglementaire
Ce dispositif est conforme à la réglementation de la IC et
(Partie 15) de la FCC. Son fonctionnement est soumis à
deux conditions : (1) ce dispositif ne doit pas causer
d’interférences nuisibles, et (2) ce dispositif doit
accepter toute interférence reçue, y compris les
interférences pouvant entraîner des conditions de
fonctionnement indésirables.
Disclaimer
This Glass Break Detector is not a complete alarm
system, but only a part. Therefore SMC does not accept
any responsibility or liability for any damage that is
claimed to be a result of an incorrect functioning of the
Glass Break Detector. SMC reserves the right to change
the specification without a prior notice.
Limitations of Security Products
Security products and alarm systems do not offer
guaranteed protection against burglary, fire, or other
emergencies. They may fail to warn for diverse reasons,
including (but not limited to): power failure, dead
batteries, improper installation, coverage, coverage
areas overlooked during installation, defeat by
technically sophisticated intruders, component failure,
or inadequate maintenance. Alarm systems should be
checked weekly to ensure that all devices are working
properly.
AN ALARM SYSTEM IS NOT A SUBSTITUTE FOR INSURANCE
Part Number: 1078204A