SME 12 - Unpacking

10
8. UNPACKING
1. UnpackandcheckallitemsagainstthepackinglistinSecon7.
2. Havingopenedthepackingboxcarefullyliupwardsthetopsecon
highdensityfoammodulewhichcoverstheturntable/tonearmunit.
Liouttheturntableliing fromunderthemainchassis(boom
ofturntable).Theturntableshouldbesitedonasubstanaltable
or strong audio stand which must be capable of supporng the
turntableweight.
3. With the turntable sited li the le side of the turntable to gain
access to the motor transit screw which secures (clamps) the
motor to the main chassis. Remove the motor transit screw and
posiontheturntablesquarelyandcentrallyontoanaudiostand.
Ensure that the motor base posts are securely inserted into the
compliance cups.
4. The turntable is shipped with only a small quanty of oil in the
bearing housing and this should be lled before seng up the
turntable.Ameasuredquantyofoilis
providedinthesyringeandneedstobe
injectedintothebearinghousing.
5. Removethesyringefromitspacking
and insertthe pintothe oilller
adaptor, which will be found
factoryednexttothespindle(as
illustrated).
6. Slowlyinjectthecompletequanty
of oil into the bearing housing
maintaining downward pressure
throughouttheoperaontoprevent
leakage. Remove the syringe and
disposeofitresponsibly
7. Unscrew and remove the oil ller
adaptor using the box spanner
found inside the tool kit. Retain the
adaptorforpossiblefutureuse.
Oil Syringe
Oil Filler Adaptor
Spindle