SME 12 - Setting up - Turntable

11
9. SETTING UP - TURNTABLE
1. Levelling
 Withtheuseofaspirit/bubblelevelensurethatthemainchassis(lower
chassis)islevelinthelateralandlongitudinalplanes.The4feetareheight
adjustableandcanbeusedtoachievealevelchassis.Whenadjusngthe
feet itis recommended to slightly li the chassis adjacentto the foot
beingadjusted.Thisaideseaseofrotaonofthefootandpreventsthe
footrubberpadbinding.
2. Transit Locks
 Fortransitthesuspensionislocked(secured)bytwoscrews;theseare
accessiblethroughholesinthedrivenpulley.Thetransitscrewsshouldbe
turnedan-clockwisewiththesupplied4mmhexwrenchandremoved.
3. Drive Belt
 1. Placethedrivebeltoverthelargedrivenpulleyandstretchoverthe
motorpulley.Slowlyturnthedrivenpulleytoallowthedrivebeltto
takeupitsnaturalrunningposion.
 2. Rotatethedrivenpulleybyhandtoensurethedrivebeltisposioned
correctlyandrotangfreely.
4. Plaer
 Unpacktheplaerandplaceitcarefullyandsquarelyovertheturntable
spindleloweringitgentlydownunlitrestsonthedrivenpulley,having
rstensuredthatbothmangsurfacesareclean.
WARNING
The unique damping material (isodamp) installed on the plaer top surface
hasbeendiamondturnedandscrolledforinmatecontactwiththerecord.
Avoidhandlingtheisodampmaterialandtreatitlikeavinylrecordasitcould
beeasilydamaged.