SME 12 - Page 12

12
9. SETTING UP - TURNTABLE (connued)
6. Power Unit & Speed Control Unit
 Thepowerunitisconnectedtothespeedcontrolunitandturntableby
wayoftheconneconcables(Secon11)withLEMO connectors.The
cablescannotbeconfusedastheycarryadierentnumberofpinswhich
arepurposelyconguredtoobservebothsafetyandmiss-idencaon.
ThecablesareidenedasAandB.
1. ConneconCableA-PowerUnitOutputtoSpeedControlUnitInput
2. ConneconCableB-SpeedControlUnitOutputtoTurntableInput
 The AC mains power cable is connected to the power unit AC input.
A push ON/OFF switch is located on the rear of the power supply unit.
IMPORTANT
The mains voltage seng is indicated on the rear panel of the power unit.
Before ng the mains power cable check carefully that this matches your
mainsvoltage.
Tonearm Set Up
TheModel12isequippedwithafactoryedtonearm.Themounngbase
canaccommodateSMEtonearms,Model309,SeriesIVandSeriesV.Referto
thetonearminstruconmanualforsetupprocedures.