EasyManua.ls Logo

Smeg AG820BC4 - Before Installation

Smeg AG820BC4
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
(7.5cm)
is required between the oven and
any adjacent walls. One side must be open.
WARNING: Do not install oven over a range cooktop or other heat-producing appliance.
If installed near or over a heat source, the oven could be damaged and the warranty
would be void.
3.0 inch(7.5cm)
3.0 inch(7.5cm)
12 inch(30cm)
OPEN
Installation
a. Leave a minimum clearance of 12 inches (30cm) above the oven.
b. Do not remove the legs from the bottom of the oven.
1. Select a level surface that provides enough open space for the intake and/or outlet vents.
Remove all packing material and accessories. Examine the oven for any damage such as dents or
Cabinet: Remove any protective film found on the microwave oven cabinet surface. Do not
Before Installation
broken door. Do not install if oven is damaged.
remove the light brown Mica cover that is attached to the oven cavity to protect the magnetron.
Operation
of microwave oven may cause interferenceto your radio or TV reception.
c. Blocking the intake and/or outlet openings can damage the oven.
d. Place the oven as far away from radios and TV as possible.
2. Plug your oven into a standard household outlet. Be sure the voltage and the frequency is
the same as the voltage andthe frequency on the rating label.
EN-8

Related product manuals