Smeg BCC01 Manual

EN - 13
EN
• Refit the service door (8) making sure it is
correctly positioned.
Do not wash the brewing group
in the dishwasher in order not to
damage it permanently.
Descaling
The coffee machine signals when it is
necessary to carry out a descaling cycle based
on the set water hardness (For the setting of the
water hardness, see the “Machine Settings”
paragraph).
If the LED (25) lights up steadily, it means
that a descaling cycle is necessary, so as not
to alter the taste of the coffee and damage the
machine. However, coffee and further drinks
may continue to be dispensed for a limited
number of cycles.
If the LED (25) flashes, it means that a
descaling cycle is mandatory to proceed with
further dispensing of drinks.
To carry out a descaling cycle, proceed as
follows:
• Place a container with a capacity of at least
1,4 l under the dispenser (11).
• Make sure that the Primary program with
white illuminated keys is selected.
• Fill the tank (5), up to the “MAX” level, with a
solution of water and descaler in the doses
recommended by the manufacturer .
• With the machine ready for use, press
the keys (20) and (18)
simultaneously for at least 3 seconds. The
key (18) flashes with an orange light
and the LED (25) has a fixed light for
the entire duration of the descaling cycle,
which has duration of several minutes.
• The descaling cycle ends when the solution
contained in the tank (5) is finished, the key
(18) and the LEDs (21) and
(25) light up fixed.
• During the descaling cycle, the machine will
take a few breaks to allow the descaler to
act effectively. Wait for the end of the cycle.
• Pour clean water into the tank (5) up to the
“MAX” level to carry out the rinse cycle, then
press the button (18) to start the rinse
cycle, the button (18) flashes and the
LED (25) lights up steadily for the entire
duration of the washing cycle.
• When the tank (5) is empty, the rinse cycle
is finished.
• The keys light up in white.
If, at the end of the descaling
process, the LED (25)
remains
permanently lit, it indicates that
a new descaling cycle must be
carried out since the quantity
of descaling solution that was
used was insufficient for complete
cleaning.
Any other servicing should be
performed by an authorized
service representative.
“Empty system” procedure
The ‘Empty system’ procedure is recommended
before long periods of non-use and before
consulting a maintenance manager.
• Activate the procedure by holding down
the key (16) and the key (19)
simultaneously for three seconds, the key
(17) and the key (19) flash
simultaneously.
Cleaning and maintenance

Smeg BCC01 Specifications

General

Product type	Espresso machine
Built-in grinder	Yes
Capacity in cups	1 cups
Grinder capacity	150 g
Coffee input type	Coffee beans, Ground coffee
Coffee maker type	Fully-auto
Country of origin	China
Appliance placement	Countertop
Water tank capacity	1.4 L
Maximum operating pressure	19 bar
Reservoir for brewed coffee	Cup
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz
Auto power off after (max)	20 min
Package depth	265 mm
Package width	495 mm
Package height	445 mm
Package weight	7000 g
Quantity per pack	1 pc(s)
Cappuccino making	No
Control type	Buttons
Product color	Red
Housing material	Aluminium, Plastic
Pallet weight	168000 g
Quantity per pallet	24 pc(s)
Pallet GTIN (EAN/UPC)	8017709301002
Quantity per pallet layer	6 pc(s)
Number of layers per pallet	4 pc(s)
Pallet net width	800 mm
Pallet net height	1900 mm
Pallet net length	1200 mm
Pallet net weight	120000 g

Weight and Dimensions

Depth	433 mm
Width	180 mm
Height	336 mm
Weight	5000 g