EN - 7
EN
Use
After 30 minutes of non-use, the
machine switches off. If it has
produced at least one drink, it
carries out a self-cleaning cycle.
Press the button (9) to switch on
the machine.
Change of dispensing program
The machine has two dispensing menus in its
memory: White and Orange. To switch from
one program to another, press the key (36).
In the White menu all the keys are illuminated
in white, in the Orange
menu, all the keys are
illuminated in orange.
For the specic functions of each menu, refer
to the paragraph “Description of controls and
alarms”
Turning off the machine the setting of
the
White or Orange
dispensing
menu remains in the memory at the
next restart.
Coffee drink supply (Espresso,
Coffee, Americano, Espresso light,
Long espresso coffee) and hot water
• Place a cup or large cup under the
dispenser.
• Press the key for the desired function. For
each selected function, preparation stops
automatically. For specic functions, refer
to the paragraph “Description of controls
and alarms”.
• At the end of dispensing, all the keys light
up xed.
Remember to reassemble the tray
(19) at the end of any dispensing.
It is completely normal that after a
prolonged inactivity of the machine
(breaks longer than 20 min
)
the
rst coffees are not at the right
temperature
.
The tips to obtain a hot
coffee immediately are given in the
section “What to do if
...”
The supply of the coffee drinks and
hot water may be interrupted at any
moment by pressing the dispensing
key.
Dispensing of drinks with milk
(Cappuccino, Latte macchiato,
Espresso macchiato, Milk foam)
Milk foam consistency may vary
depending on the type of used
milk. To obtain a good result, it
is advised to use whole or semi-
skimmed milk at fridge temperature
(approximately 5°C).
It is necessary to proceed as follows to prepare
these drinks:
Connection of the milk tube
(Fig. C)
• Open the safety cap (15).
• Connect the milk tube (24) to the dispenser,
taking care to insert the correct coupling
to the connection (16) envisaged on the
dispenser, as shown in gure C and to
completely immerse the other end.
Make sure the level of milk in the
container used does not exceed the
tube connection height.
To Next Page
Loading...
Need help?
General
