EN - 13
EN
Open the door and clean the
brewing unit while the machine is
on. This is the only way of resetting
the counter.
The counter resets at least 10
seconds after opening the various
components and LED 40 turns off.
We recommend running a manual
circuit cleaning cycle whenever this
operation is performed.
Please see paragraph “Manual
rinse” for this reason.
Do not wash the brewing group
in the dishwasher in order not to
damage it permanently.
Coffee powder residue can be found
in the brewing group compartment.
We recommend thorough cleaning
whenever cleaning the brewing
group. Use the supplied brush
to remove any residue from the
brewing group compartment.
Dry all components and internal
parts using a dry cloth before
closing the side door.
Descaling
Before performing the descaling
cycle, remove possible softener
lters inside the tank.
The coffee machine signals when it is
necessary to carry out a descaling cycle based
on the set water hardness (For the setting of
the water hardness, see the “Setting the water
hardness” paragraph).
If the LED (41) lights up steadily, it means that
a descaling cycle is necessary, so as not to
alter the taste of the coffee and damage the
machine. However, coffee and further drinks
may continue to be dispensed for a limited
number of cycles.
If the LED (41) ashes, it means that a descaling
cycle is mandatory to proceed with further
dispensing of drinks.
To carry out a descaling cycle, proceed as
follows:
•
Position a container with a capacity of at
least 1,4 l under the dispenser (11).
• Make sure that the
White
program with
white illuminated keys is selected.
• Fill the tank (5), up to the “MAX” level, with a
solution of water and descaler in the doses
recommended by the manufacturer
.
• With the machine ready for use, press the
keys (36) and (32) simultaneously for at
least 3 seconds. The key (32) ashes with
an orange light and the LED (41) has a xed
light for the entire duration of the descaling
cycle.
• Stay near the machine for the entire duration
of the descaling cycle since you may be
required, for example, to ll the tank (5). The
entire cycle lasts approximately 30 minutes.
• During the descaling cycle, the machine will
take a few breaks to allow the descaler to
act effectively. Wait for the end of the cycle.
• The descaling cycle ends when the solution
contained in the tank (5) runs out, the key
(32) turns white and the led (41) lights up
steady.
• Pour clean water into the tank (5) up to the
“MAX” level to carry out the rinse cycle,
then press the button (32) to start the rinse
cycle, the button (32) ashes and the LED
(41) lights up steadily for the entire duration
of the washing cycle.
• The rinse cycle ends when the keys light up
white.
Cleaning and maintenance
To Next Page
Loading...
Need help?
General
