26
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
GENERAL ALARM: REFER TO
USER MANUAL
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as
described in section “Cleaning”. If the message is
still displayed after cleaning, contact an authorised
Customer Service centre.
Reminder that appliance needs de-scaling
and/or the lter (C4) must be replaced.
The de-scaling procedure described in section “De-
scale” needs to be performed as soon as possible
and/or the lter needs replacing or removing as de-
scribed in section “Water softener lter”.
Reminder that tubes inside the milk con-
tainer (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g.21).
Reminder that lter (C4) must be
replaced.
Replace the lter or remove it as described in section
“Water softener lter”.
Reminder that machine must be
de-scaled.
The de-scaling procedure described in section “De-
scale” needs to be carried out as soon as possible.
Indicates that the auto-start function is
enabled.
To disable the function, proceed as described in par.
"Auto-start ".
Energy saving is enabled. To disable energy saving, proceed as described in par.
"Energy saving ".
Indicates that the lter (C4) has been
enabled
To remove the lter, proceed as described in section
“Water softener lter”.
CLEANING
PLEASE WAIT
The appliance has detected impurities in
its internal circuits.
Wait for the appliance to be ready for use again and
reselect the required beverage. Contact an Author-
ised Customer Service Centre if the problem persists.
MACHINE TOO HOT Using the stirrers continuously for long
periods may cause the appliance to
overheat
Wait for the appliance to cool down.
To Next Page
Loading...
Need help?
General
