Smeg DCF01 User Manual

Use
33
ENEN
4. Close the lid (1) by lowering the tab.
5. Place the jug (5) with the lid (6) on the
Keep Warm plate (7)
. Make sure that
the lid fits perfectly into the anti-drip
valve (8).
6. Press the ON/OFF button to enable
the BREW mode
: The LED on the ON/
OFF
button lights up and flashes
quickly for the entire time the coffee is
being brewed.
7. You can stop the coffee from being
brewed at any time by pressing the
ON/OFF button. The appliance
stops, emits a beep and the clock
reappears on the display.
• One level scoop of ground
coffee is approximately
equivalent to one cup. However,
the amount of ground coffee to
be used may vary according to
personal taste.
• Use good quality medium
ground coffee.
It is normal for steam to be
produced while the coffee is being
brewed.
Danger of burns
• Do not open the lid of the water tank
while the coffee is being brewed.
Warning
• Do not open the lid of the drip coffee
machine at the end of the brewing cycle.
Wait at least 5 minutes after the brewing
cycle has finished before opening the
lid.
• After 5 minutes, you can remove and
clean the filter and refill the water tank in
order to start a new brewing cycle.

Smeg DCF01 Specifications

General

Jug capacity	1.25 L
Product type	Espresso machine
Capacity in cups	10 cups
Coffee input type	-
Coffee maker type	Semi-auto
Appliance placement	Countertop
Water tank capacity	1.4 L
Keep warm function time	20 min
Adjustable coffee strength	Yes
Reservoir for brewed coffee	Jug
Number of coffee strength settings	2
Cord length	1 m
Control type	Buttons, Lever
Product color	White
Housing material	Plastic, Stainless steel
Ristretto making	No
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	256 mm
Width	245 mm
Height	361 mm
Weight	3400 g