Smeg DD612SC - Page 7

User instructions

INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
• press one of the
SELECTION PROGRAMS
buttons
(2)
, the light of
the current phase will go out;
• keep the button pressed until the
PHASES/PROGRAM
lights
(7)
come on (confirmation buzzer);
• start the program (see “
S
TART PROGRAM
”).
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “
I
NTERRUPTION OF A PROGRAM
”);
• select the new program;
• start the program (see “
S
TART PROGRAM
”).
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“
I
NTERRUPTION OF A PROGRAM
”).
Now press buttons
P1
+
P2
simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TART PROGRAM
”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.