To Next Page

To Previous Page

User instructions

START PROGRAM

At this point, in order to start the machine, it is only enough to press the

START/PAUSE (6) for some seconds until the symbol START/PAUSE

(D) start to flash and confirmation “beep” is heard. From this moment the

cycle duration on the DISPLAY (9) starts to decrease.

This phase, that updates itself during the cycle, is “indicative” since it is

influenced by the washing conditions such as dishwasher type and

quantity, entry temperature etc. For this reason it is normal to see the

updating during a program (increment and decrease of minutes)

specially in the passage from one phase to the other (for example, from

washing to rinse).

END PROGRAM

The end of the program is indicated by a short signal acoustic and from

the “End” visual notification on DISPLAY. By pressing one of the

buttons, the “End” visual signal will vanish from the display and the

dishwasher is ready to continue a new cycle.

INTERRUPTING

PROGRAM

In order to interrupt a running program it is necessary:

• to press the START/PAUSE for some seconds until when the

symbol START/PAUSE remains lit on the display (confirmation

beep). At this point,it is possible to start the cycle again, otherwise:

•

TO CHANGE A PROGRAM

To change the running program it is necessary:

• to interrupt the running program (see “INTERRUPTING A PROGRAM”);

• select the new program;

• to press again the START/PAUSE button to make start the new

program.

Smeg DI6013NH User Manual

Other manuals for Smeg DI6013NH