Do you have a question about the Smeg DWAFI152T and is the answer not in the manual?
Commercial warranty | 2 years |
---|---|
Number of Place Settings | 15 |
Soak | Yes |
Express 27' | Yes |
Full express - 60' | Yes |
ECO | Yes |
Auto 45-65 | Yes |
Intensive | Yes |
Hygiene 99,9% | Yes |
Controls | Electronic |
Salt light indicator | Yes |
Rinse aid indicator | Yes |
Energy consumption – standby mode | 0.5 W |
Minimum plinth height | 100 mm |
Material tub | Stainless steel |
Maximum dish diameter loadable on lower basket | 30 cm |
Power consumption in off-mode | 0.5 W |
Power rating | 1900 W |
Voltage | 220-240 V |
Frequency | 50 Hz |
Automatic programmes | Yes |
Extra dry | Yes |
Special programmes | Yes |
Category | Dishwasher |
Installation | Freestanding |
Size | 60 cm |
Door colour | Pastel blue |
Panel colour | Pastel blue |
Washing temperatures | 45°C, 65°C, 70°C |
End of cycle indicator | Yes |
Drying system | Condensation drying |
Water softener | Yes |
Flood protection system | Yes |
Door balance | Yes |
Upper basket adjustment | Yes |
Lower basket | Foldable |
Cutlery basket | Yes |
Colour Inner Components | Stainless steel |
Energy consumption [per 100 cycles, based on the eco programme] | 0.93 kWh |
Length of inlet pipe | 1.5 m |
Door opening system | Yes |
Half Load | Yes |
Delay timer | Yes |
Energy consumption per cycle | 0.93 kWh |
Details on connecting the water supply hose, preventing clogging, and using new hoses.
Guidelines for mains connection, plug type, socket compatibility, and safety measures.
Explains the buttons and indicator lights on the upper control panel.
How to adjust and use the water softening system with regenerating salt.
Instructions for adding and using rinse aid and detergent.
Advice on dish types, loading, and pre-washing before first use.
Guidance on loading the lower and upper baskets, including accessories.
General advice on cleaning, avoiding harsh detergents, and unplugging the appliance.
Steps for cleaning water intake filter and spray arms.
Guide to cleaning filter unit and preparing after inactivity.
Common issues like program start failure, water retention, and poor cleaning.