Instructions
38
Installation
• THIS APPLIANCE MUST NOT BE
INSTALLED ON BOATS OR IN
CARAVANS.
• Do not install the appliance in
areas exposed to rain, direct
sunlight or close to heat sources
(ovens, hobs etc.).
• Do not install the appliance in
rooms in which there are
flammable gases.
• Install the refrigerator in a dry well
ventilated room.
• The appliance must be earthed in
compliance with electrical safety
standards.
• Install the appliance on a stable
and perfectly level floor.
• Do not use the door handles for
handling the appliance.
• Only use the special handle to
move the appliance.
• For safety reasons, the refrigerator
must be moved by at least 4
people.
• Transport the refrigerator with the
doors facing upwards.
• Secure the doors firmly with
adhesive tape so that they cannot
open.
• If it is transported by road, do not
place the appliance on its side to
avoid damaging the compressor.
• Use a sheet of plastic or a
protective cloth to protect the floor
and to collect any water that may
leak from the refrigerator.
• Do not use the wheels of the
appliance to move it on delicate
floors as they may become
scratched.
For this appliance
• The appliance uses R-600a as a
refrigerant and cyclopentane for
the thermal insulation of the
polyurethane. The R-600a
refrigerant is flammable. The
refrigerant is sealed in the
refrigerant circuit and cannot leak
during normal use.
To Next Page
Loading...
