EasyManua.ls Logo

Smeg LB1T60ES - User Manual

Smeg LB1T60ES
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Washing Machine / User Manual
EN
LB1T60ES

Questions and Answers

  • M
    Meagan BlevinsAug 14, 2025
    How to fix a Smeg LB1T60ES Washer that won't start?
    • N
      nancynelsonAug 14, 2025
      If your Smeg Washer doesn't start, several factors could be at play. First, ensure the machine is properly plugged into a functioning power outlet. Check the fuses and replace them if they are faulty. Verify that there is mains power supply. Make sure you have pressed the Start/Pause button. Also, ensure the program dial is not in the ‘stop’ position; if it is, turn it to the desired setting. Finally, confirm that the machine door is completely closed.
  • K
    Kim DickersonAug 17, 2025
    What to do if my Smeg Washer does not discharge water?
    • L
      Lindsey StricklandAug 17, 2025
      If your Smeg Washer isn't discharging water, inspect the drain hose for clogs or twists; clean or untwist it as needed. Also, the pump filter might be clogged, so clean it. Ensure that your laundry is spread evenly in the machine.
  • K
    kgallagherAug 20, 2025
    How to improve washing results with my Smeg LB1T60ES?
    • J
      Jose JonesAug 20, 2025
      If you're not getting satisfactory washing results from your Smeg Washer and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, make sure that your laundry is spread out in the drum.
  • P
    patrick59Aug 25, 2025
    Why is the spin cycle delayed on my Smeg LB1T60ES?
    • J
      James LarsonAug 25, 2025
      If the spin cycle on your Smeg Washer doesn't start or starts later than expected, it's likely that the Unbalanced load control system has been activated. This system will attempt to spread your laundry. The spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.
  • M
    Michael HayesAug 27, 2025
    Why is my Smeg Washer not intaking water?
    • C
      Cheryl AndersonAug 27, 2025
      If your Smeg Washer isn't taking in water, start by checking if the water tap is turned on. Next, inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or the inlet filter may be clogged, so clean these filters. Finally, ensure that the machine door is completely closed.
  • E
    Elizabeth FrenchAug 30, 2025
    How to stop my Smeg LB1T60ES Washer from vibrating?
    • M
      Michael CaldwellAug 31, 2025
      If your Smeg Washer is vibrating, make sure the feet have been properly adjusted. Another potential cause is the transit bolts, which are fitted for transportation; these need to be removed. Avoid setting up your washing machine on a hard surface. Also, ensure that the machine is not overloaded and that the laundry is spread evenly in the drum.
  • L
    Lynn RyanSep 3, 2025
    Why is there so much foam in my Smeg LB1T60ES Washer detergent drawer?
    • W
      william73Sep 3, 2025
      If you notice excessive foam in the detergent drawer of your Smeg Washer, it could be due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 litre of water and pour it into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Ensure you only use detergents specifically produced for automatic washing machines.
  • T
    Tabitha DoughertySep 7, 2025
    Why does my Smeg LB1T60ES discharge water as soon as it is loaded?
    • D
      David WoodSep 7, 2025
      If your Smeg Washer is loaded with water and the water discharges immediately, it means that the end of the water drain hose is too low for the machine. Check that the drain hose is at a suitable height.
  • B
    Brittney JonesSep 9, 2025
    Why is my Smeg Washer not washing clothes properly?
    • C
      costarichardSep 9, 2025
      If you're not getting satisfactory washing results from your Smeg Washer, consider whether your laundry is too dirty for the selected program; if so, select a more appropriate program. Also, ensure you're using enough detergent as instructed on the packaging. Finally, check that you have not exceeded the maximum laundry capacity for the selected program.

Smeg LB1T60ES Specifications

General IconGeneral
Model NumberLB1T60ES
BrandSmeg
Loading typeFront Loading
Capacity6 kg
Spin speed1000 rpm
Energy efficiency classA+++
Noise level spinning74 dB
InstallationFreestanding
ColourWhite
Number of Programs15
ColorWhite
Dimensions (H x W x D)60 x 60 cm

Related product manuals